Panasonic Corporation of North America 9TGCF-736 ユーザーズマニュアル

If the function fails to operate correctly

Read the operating instructions for the access point carefully and check the settings.

„ The access point fails to be displayed in [Available Networks]

z Select the profile you are using, and select [Advanced] in [Networks].  [Connect to ad hoc 

networks only] may have been selected in [Connection preference].   In this case, select 
[Connect to infrastructure and ad hoc networks].

z This computer uses channels 1 through 11

.  Check the channel being used.

*1

In the case of wireless communications, the frequency band being used can be divided into 
segments, so that different communications can be conducted on each band segment.  A "Channel" 
refers to the individual frequency bandwidth divisions.

„ The access point cannot be accessed

z The network key setting may not conform to the access point.

Check the network key setting of the access point and, if necessary, set it again correctly.

z Depending on the access point and settings, access may not be accepted unless the 

computer's MAC address is registered beforehand.   In this case, check the computer's 
MAC address using the following procedure and register it according to the operating 
instructions of the access point.

Display [Command Prompt].

Windows XP

Select [Start] - [All Programs] - [Accessories] - [Command Prompt].

Windows 2000

Select [Start] - [Programs] - [Accessories] - [Command Prompt].

Input [ipconfig /all], and press 

Enter.

Make a note of the 12-digit string of alphanumerics displayed on "Physical 
Address" line on Wireless LAN side.  Then input [exit], and press 

Enter.

„ The IP address of the access point is wrong

z Following the operating instructions of the access point, set the IP address of the access 

point again correctly.