Napco Security Systems Inc 2WAYRCVR ユーザーズマニュアル
11
STEP 2
- ENROLLING KEYFOBS--With ADEMCO Panels/Keypads
Enrolling and Removing KeyFobs
Each KeyFob must be enrolled into the receiver. The following procedure is used to enroll the unique RF ID number
stored in the non-volatile memory of each KeyFob into the receiver memory.
stored in the non-volatile memory of each KeyFob into the receiver memory.
1
Arm system from any keypad
2
Disarm system from any keypad
3
Press 1114, then [AWAY] on keypad
The Enroll Mode LED will flash rapidly.
The keypad may sound error beeps* - ignore.
4
Press the
∗
button on KeyFob 1
The KeyFob will sound a single confirmation beep.
....
Repeat for each KeyFob to be enrolled
Press
C
on Keypad
Exit Enroll Mode - the Enroll Mode LED will slowly pulse. The
KeyFob will give a series of beeps and the unlock icon will
display.
KeyFob will give a series of beeps and the unlock icon will
display.
•
The Keyfob Enroll Mode may also be entered / exited by pressing the the Enroll Mode Push Button on the top of the
receiver. See page 18 for more information.
receiver. See page 18 for more information.
•
To Remove a lost KeyFob from the system: Enter and then exit the Keyfob Enroll Mode (Arm and disarm the
system, enter 1114 [AWAY] and then press [#] ). All keyfobs will be deleted from the system.
system, enter 1114 [AWAY] and then press [#] ). All keyfobs will be deleted from the system.
For NAPCO "Classic" Keypads, see pages 9 and 12.
For NAPCO "K Series" Keypads, see pages 10 and 13.
Bus
Mode Op
era
tion
tion
*
Some Vista models will beep, others will not. Ignore all beeps.
2WAY-UNIVKF_WI1024J.19_I...
page 11
page 11
Friday, February 13, 2004 08:57
Composite