Napco Security Systems Inc 2WAYRCVR ユーザーズマニュアル
13
STEP 3
- ENROLLING USER CODES--With NAPCO "K Series" Keypads
Enrolling User Codes into the 2 Way receiver
After all KeyFobs have been enrolled as described in step 2, a 4-digit User Code must be enrolled into the receiver for each KeyFob.
If you have enrolled 3 KeyFobs, you must program into the control panel (3) 4-digit User Codes and then use the following procedure
to enroll these User Codes into the receiver. The receiver will hold these User Codes in its non-volatile memory and use them to arm/
disarm the system upon command from the KeyFob. This User Code Enrollment feature allows the control panel to uniquely identify
each KeyFob used to arm and disarm the system, log KeyFob opening/closing activity in its event buffer and report openings and
closings by KeyFob user if desired. Note: Before proceeding, a 4 digit User Code representing each KeyFob must be
programmed into the control panel.
If you have enrolled 3 KeyFobs, you must program into the control panel (3) 4-digit User Codes and then use the following procedure
to enroll these User Codes into the receiver. The receiver will hold these User Codes in its non-volatile memory and use them to arm/
disarm the system upon command from the KeyFob. This User Code Enrollment feature allows the control panel to uniquely identify
each KeyFob used to arm and disarm the system, log KeyFob opening/closing activity in its event buffer and report openings and
closings by KeyFob user if desired. Note: Before proceeding, a 4 digit User Code representing each KeyFob must be
programmed into the control panel.
1
Arm system from any keypad (using any User Code)
2
Disarm system from any keypad
3
Press 1113
U
The keypad will give error beeps - ignore.
Enroll Mode LED will flash / pulse
4
Enter 4 digit User Code for KeyFob # 1, press
Q
System will Arm
5
Reenter the 4 digit User Code for KeyFob # 1,
U
System will Disarm
6
Observe automatic reciever test of user code.
System will test User Code by quickly Arming
and Disarming
and Disarming
...
Repeat steps 4 & 5 for each KeyFob to be enrolled.
•
Press
C
on Keypad
Exit Enroll Mode-the Enroll Mode LED will slowly
pulse
pulse
Note: If these user codes are changed in control panel programming,
the new user codes must be re-enrolled into the receiver.
the new user codes must be re-enrolled into the receiver.
For NAPCO "Classic" Keypads, see pages 9 and 12.
For Ademco Keypads, see pages 11 and 14
For Ademco Keypads, see pages 11 and 14
Bus
Mode Op
era
tion
tion
NAPCO "Classic" Keypads
NAPCO "K Series" Keypads
GEM-RP1CAe2, GEM-
RP2ASe2, GEM-RP3DGTL
GEM-K1CA, GEM-K2AS,
GEM-K3DGTL, GEM-K4RF
2WAY-UNIVKF_WI1024J.19_I...
page 13
page 13
Friday, February 13, 2004 08:57
Composite