ICOM 272105 ユーザーズマニュアル

BIIS OPERATION

■ Transmitting a call

Total of a 3 ways for code selection are available—selecting
the call code from memory, entering the call code from the
keypad and calling back from the queue channel record.

D Using call memory

q While in the standby condition, push [P1] (Digital) to enter

the call code memory channel selection mode.

• “

” appears.

w Push [UP] or [DOWN] to select the desired call code.
e Push [P0] (Call) or [PTT]* to call.

*PTT call can be made only when PTT call capability is permitted.

NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and “

”

is displayed during each call. However, an

error beep sounds and “

”

is displayed when no

answer back is received after the calls.

r Push [PTT] to transmit; release to receive.
t Push [MONITOR] (Moni(Audi)) to send the ‘Clear down’

signal.

D Calling back from the queue channel

q While in the standby condition, push [P1] (Digital) for

1 sec. to enter the queue memory channel selection mode.

w Push [UP] or [DOWN] to select the desired record.

e Push [P0] (Call) or [PTT]* to call.