ICOM IC-703 ユーザーズマニュアル
20
3
BASIC OPERATION
• 1 Hz and 10 Hz tuning steps
When neither the quick tuning step or programmable
tuning step “
tuning step “
Z
” appear, rotating the main dial
changes the frequency in increments of 1 or 10 Hz.
These tuning steps are only available in SSB, CW
and RTTY modes.
These tuning steps are only available in SSB, CW
and RTTY modes.
qSelect SSB, CW or RTTY mode if necessary.
wPush [TS] for 1 sec. to toggle between the 1 Hz
and 10 Hz step settings.
• When the 1 Hz step is selected, the 1 Hz digit appears
in the frequency indication; when the 10 Hz step is se-
lected, the 1 Hz digit disappears from the frequency in-
dication.
lected, the 1 Hz digit disappears from the frequency in-
dication.
• Rotating the main dial changes the frequency 1 Hz or
10Hz tuning step.
Rotating the main dial
changes the frequency
in 10 Hz steps.
changes the frequency
in 10 Hz steps.
Rotating the main dial
changes the frequency
in 1 Hz steps.
changes the frequency
in 1 Hz steps.
TS
Push
for 1 sec.
VFO A
USB
VFO A
USB
[TS]
[MODE]
Main dial
• 1 MHz quick tuning step
The quick tuning step function allows you to change
the frequency in 1 MHz steps when rotating the main
dial. This function is only available in FM and AM
modes.
the frequency in 1 MHz steps when rotating the main
dial. This function is only available in FM and AM
modes.
qSelect FM or AM mode if necessary.
wPush [TS] momentarily to toggle between the 1
MHz tuning step and the programmable tuning
step.
step.
• “
Z
” appears above the 1 MHz indicator when the 1
MHz tuning step is selected.
• Rotating the main dial changes the frequency 1 MHz or
set tuning step.
Quick tuning step
indicator
indicator
FM
FM
Rotating the main dial
changes the frequency
in 1 MHz steps.
changes the frequency
in 1 MHz steps.
[TS]
[MODE]
Main dial
3