Vizbee SAS PTAG101 ユーザーズマニュアル
RFID Tag (FCC ID : 2AA2YPTAG101)
Installation Instructions and User Manual
1.
General
The RFID tag is used for locating persons and assets in a defined area, which is covered by a
network of RFID readers (FCC ID: 2AA2YREADER101).
It can be also used as a gateway between a network of readers and a host computer.
network of RFID readers (FCC ID: 2AA2YREADER101).
It can be also used as a gateway between a network of readers and a host computer.
2.
Installation Instructions
2.1.
Using the Device as a Tag
The device may be used by a person (for example by using a special pocket or just by putting the
tag into a badge holder). The device may be installed on physical items, such as computers,
mechanical machines or any other asset. In that case, the device may be installed by fixing it to
the asset by a glue or by holding it with a holder of any other type.
tag into a badge holder). The device may be installed on physical items, such as computers,
mechanical machines or any other asset. In that case, the device may be installed by fixing it to
the asset by a glue or by holding it with a holder of any other type.
2.2.
Using the Device as a Gateway
When using the tag as a gateway it should be connected to a computer using a simple USB to
Mini-USB standard cable.
Mini-USB standard cable.
3.
Operation Instructions
3.1.
Activating the Device
Once installed, the device should be activated by pushing the led on the side of the device 3
consecutive times. The device should flash red 3 times and then start blinking in red.
consecutive times. The device should flash red 3 times and then start blinking in red.
3.2.
Verifying Connectivity for Tag Mode
If there is a reader device in the area, the device should start blinking in green after a while. If
there is not reader present at the proximity of the device it will blink red.
there is not reader present at the proximity of the device it will blink red.
3.3.
Turning the Device Off
The device is turned off by pressing the led on the side of the device 3 consecutive times. The
device will flash green 3 times and then will turn off.
device will flash green 3 times and then will turn off.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference and
following two conditions:
(1) This device may not cause harmful interference and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
may cause undesired operation.