CEI Conrad Electronic International Limited RCL-RR8-TP ユーザーズマニュアル
Transmitter | 17
Depending on the stick/switch configuration, switch and stick input make the channel bars
move to the left (lower extent) or right (upper extent) when viewed in the "Display" menu
(see '11.5.3 Display' on page 17).
Study the diagram of
move to the left (lower extent) or right (upper extent) when viewed in the "Display" menu
(see '11.5.3 Display' on page 17).
Study the diagram of
to get a better understanding of end point settings. The
diagram shows two different lower extent end point settings (100 % and 30 % respectively)
for the same channel. Stick travel (denoted by x) remains the same in each case.
for the same channel. Stick travel (denoted by x) remains the same in each case.
Fig. 8
Ch2
Ch2
100%
100%
0
100%
30%
100%
0
Setting the endpoints:
1. Navigate to the end point section in the »Transmitter’s menu.
1. Navigate to the end point section in the »Transmitter’s menu.
2. Select a channel with the key OK.
3. Adjust the percentage values with the keys UP and DOWN. Confirm the settings with
the key OK. The arrow jumps to the next channel.
» The left column displays the lower extent values and the right column the upper
extent values.
» To switch from lower extent to upper extent and back, move the corresponding
channel stick/switch in the corresponding direction.
4. Set the other channels.
5. To save and exit the end point settings press and hold the key OK.
5. To save and exit the end point settings press and hold the key OK.
11.5.3 Display
displays the real-time status (upper and lower extent) of
each channel (channel input). In the student mode, the settings of the trainer's transmitter
are displayed.
are displayed.
Navigate and set:
Functions > OK > Display > OK > OK/Cancel
Functions > OK > Display > OK > OK/Cancel
Fig. 9
Ch1
Ch2
Ch3
Ch4
Ch5
Ch6
Display
11.5.4 Auxiliary channels
Navigate and set:
Functions > OK > Aux. channels > OK > UP/DOWN > OK > ... > OK (long)
Functions > OK > Aux. channels > OK > UP/DOWN > OK > ... > OK (long)
This function lets you assign an auxiliary control (switch or analog knob) to channels 7
and 8. Channel 1, 2, 3 and 4 are assigned to the sticks (reserved).
Source designations:
and 8. Channel 1, 2, 3 and 4 are assigned to the sticks (reserved).
Source designations:
> Switches:
SwA, SwB, SwC, None (no assignment)
> Analog:
VrA, VrB
Only channels 5, 6, 7, and 8 are assignable.
11.5.4.1 Assign switches/analog knobs
1. Navigate to the "Aux. channels" section.
2. Select a channel with the key UP or DOWN and continuously press the key OK to
2. Select a channel with the key UP or DOWN and continuously press the key OK to
select a switch/analog knob.
3. Press the key UP or DOWN to select the next channel.
4. When you have set all channels according to your needs, press and hold the key OK
4. When you have set all channels according to your needs, press and hold the key OK
to save all settings and exit the menu, or press the key CANCEL to exit without saving.