TECNICAS CIENTIFICAS PARA LABORATORIO S.A. T620 ユーザーズマニュアル
ISEsweat
- User’s Manual 21
Choose the correction factor that shows in the sensor
card box, if there is not any specified on the box, choose
5. Skip through this by pressing <ENT>
5. Skip through this by pressing <ENT>
An information screen on the linking between the base and
the remote will appear automatically, and the device will
proceed to the linking. To indicate this process, the base
unit will emit a series of 3 beeps
Press the remote module central button and keep it
pressed during the process. Do not let it go until the
base stops beeping.
base stops beeping.
During this 10 seconds (approximately) interval, while you
keep .the remote module button pressed, the remote LED
will indicate that the remote is correctly linked by the
following color sequence
keep .the remote module button pressed, the remote LED
will indicate that the remote is correctly linked by the
following color sequence
WARNING: Keep in mind that it is very important to keep the central button of the remote
pressed all the time until the linking is done, otherwise the process will be interrupted, and you
will have to initiate the process again until linking is successfully completed.
pressed all the time until the linking is done, otherwise the process will be interrupted, and you
will have to initiate the process again until linking is successfully completed.
When linking is completed, the menu screen will change to
the start screen menu, thus showing that correct linking
between the base and the remote has occured.
the start screen menu, thus showing that correct linking
between the base and the remote has occured.
CAUTION: In order to have good communication between the base and the remote, the
distance between the two must not be over 10 meters. If you increase this distance, there is
the possibility that the link between the remote and the base breaks which could lead to some
errors.
the possibility that the link between the remote and the base breaks which could lead to some
errors.
NOTE: Interruption of the analysis. You can stop the test at any time by pressing the button
on the remote unit until the LED remains orange (4 seconds) and release. Return to the Home
screen.