Practical House SRUSV1 ユーザーズマニュアル
SYNCHRONIZATION:
Before first use, you will need to initialize your Smart-Reader. Please check your Smart-Lock ‘Setup and Use’ documentation to proceed or visit
okidokeys.com
Note : If you're already using an OKIDOKEYS Smart-Lock, you will need to do full reset before adding a new Smart-Reader:
Note : If you're already using an OKIDOKEYS Smart-Lock, you will need to do full reset before adding a new Smart-Reader:
On the web portal (portal.okidokeys.com) :
• Find the «Edit the Smart-Lock» page by clicking on your door name on the dashboard.
• Go to the Advanced section and click on the «Reset the Smart-Lock» button
On your Smart-Lock :
• Remove the cover
• Use the provided screw-driver and press the Reset button (under the left top hole) for 10 seconds
The OKIDOKEYS Smart-Reader allows you to lock and unlock your
Smart-Lock using both cell-phones and smartphones without BLE
(Bluetooth 4.0). When used, these phones will emit an audible tone
that the Smart-Reader can use to unlock the Smart-Lock.
The Smart-Reader is also able to read OKIDOKEYS Smart-Tags to lock
and unlock the Smart-Lock.
Your OKIDOKEYS Smart-Reader also includes a wireless bell using the
Your OKIDOKEYS Smart-Reader also includes a wireless bell using the
Smart-Lock speaker to warn you when someone is at the door.
1
2
GETTING STARTED:
INSTALLING YOUR SMART-READER
NEXT STEPS:
Remove the back from the
Smart-Reader.
Take a picture or write down
the 17-character serial number
on the sticker in the battery
compartment. This will be used
to register your Smart-Reader
online.
Install the three AAA batteries.
3
4
Insert and tighten the T-10 (Torx)
screw from the bottom of the
Smart-Reader cover.
Select a place near you door, not
to exceed 10 ft from your
Smart-Lock. Clean the area with a
dry cloth.
Remove the film from the adhesive
on the back of the Smart-Reader.
Press the Smart-Reader firmly to the
surface you have selected.
5
The installation process is
complete.
You are now ready to register
your Smart-Reader online.
*
The batteries in your Smart-Reader can
be replaced by simply removing the T-10
screw and lifting the front of the
Smart-Reader off.
Change the batteries and replace the
Smart-Reader and T-10 screw.
WARNING:
Your Smart-Reader
includes a safety alarm to avoid external
damages.
You will need to unlock your Smart-Lock
prior to opening the Smart-Reader to
avoid triggering the alarm. If the alarm is
triggered, use an authorized Smart-Key
to stop the alarm.
PARTS LIST:
1
(x3) AAA Batteries
2
(x1) Smart-Reader
3
(x1) T-10 (Torx) Screw
4
(x1) T-10 (Torx) Screwdriver
5 (
Varies
) Card
6 (
Varies
) Wristband
7 (
Varies
) Keychain
1
2
5
7
6
4
3
SMART-READER INSTALLATION GUIDE
C
M
Y
CM
MY
CY
CMY
K
Smart-Reader Installation Guide V5.pdf 1 8/28/2014 12:04:26 PM