LED Roadway Lighting Ltd. 0115 ユーザーズマニュアル

Doc ID xxxxx Rev 1

15/19

   

   

   

D

R

A

F

T

This series of modules has been designed to meet national regulations for world wide use. 
Different versions of modules belonging to the same series are orderable as it is specified in 
the 

. They differ in terms of  integrated memory size and protocol stack enabled 

to run while sharing  the same manufacturing , design and radios capabilities. As 
representative of the series from the RF design and radios capabilities, the versions using 
128 kB Flash/8kB RAM and Zigbee PRO Protocol stack (i.e. SPZB32W1A1.1 and 
SPZB32W1C1.1) have been used during the certification tests. The following certifications 
have been obtained.

The SPZB32W1A1.1 device, with integrated antenna, as well as the SPZB32W1C1.1, with 
the antenna specified in 

, have been tested and found to comply with the limits for a 

Class B digital device , pursuant to part 15 of the FCC rules. These limits are designed to 
provide reasonable protection against harmful interference in a residential installation. 

This equipment generates, uses and can radiate radio frequency energy and, if not installed 
and used in accordance with the instructions, may cause harmful interference to radio 
communications.

However, there is no guarantee that interference will not occur in a particular installation. If 
this equipment does cause harmful interference to radio or television reception, which can 
be determined by turning the equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following measures:

●

Reorient or relocate the receiving antenna

●

Increase the separation between the equipment and receiver

●

Connect the equipment into an outlet on a circuit different from that to which the 
receiver is connected

Consult the dealer or an experienced radio/TV technician for help

Module type: ZigBee®  module       SPZB32W1A1.1 / SPZB32W1C1.1

FCC-ID: S9NZB32C1

Modular type: single modular

         

Any changes or modifications not expressed approved by the part responsible for 
compliance could cause the module to cease to comply with FCC rules part 15, and thus 
void the user’s authority to operate the equipment.

While the applicant for a device into which the SPZB32W1A1.1 or the SPZB32W1C2.1 with 
the antenna specified in 

 installed is not required to obtain new authorization for the 

module, this does not preclude the possibility that some other form of authorization or 
testing may be required for the end product.

1

2010B4844-01 (Titanis Antenna)

Antenova