Avonwood Developments Ltd ZSR6663 ユーザーズマニュアル
8
9
The range on the Plus Reader can be adjusted to detect tags between 1 and 4 metres away. The adjuster is marked
as
RV1
in Figure 2 on the previous page. Using a flat bladed screwdriver, turn the adjuster to change the size of the
detection zone.
• Turn the adjuster clockwise to increase the size of the detection zone
• Turn the adjuster anti-clockwise to decrease the size of the detection zone
Please note - Maximum and minimum range can be affected by the mounting location of the unit and power
supply ratings.
4.4. Adjusting The Range
The fixing of the reader can be done from inside the unit through 4 holes drilled by the user as indicated in figure 3
on the opposite page.
Please note there is the option for mounting the reader using Ball mount fixings via the four central threaded inserts
on the back as indicated in figure 3 on the opposite page.
To drill the fixing holes:
• Place the back section of the reader so the drill point marks in the plastic are facing up. Make sure you have
something underneath where you are drilling so that in the event the drill bit goes too far through the plastic
you protect whatever is underneath from being damaged.
• Drill using a 4.2 to 4.5 mm spur point drill bit so that you have four holes which can take a 4mm diameter wood
screw or similar.
• Use a manual screwdriver when tightening the fixing screws. Do not overtighten so as to reduce accidental
damage to the enclosure.
Cable glands can be installed either through the top or bottom flat side of the enclosure rear section. Carefully drill
and enlarge holes to suit the glands as required.
4.5. Fixing The Plus Reader To The Wall
Figure 3
Gland Size
Drill Point
Hole Size
M16
A
16mm
M20
B
20mm
The enclosure can be mounted via a ball mounting kit. Various
fixing options are available and kits can be supplied by Avonwood.
For all mounting styles available you will need a ball mount base
kit, for this product we offer one kit for the ball mount.
4.6. Ball Mounting Option
EURIDM0000 – Ball Mount Base Kit
(Supplied with Fixings)
Top View
Back View
Bottom View