QINGDAO TRI-LINK LOCK GROUP CO. LTD 318SERIES ユーザーズマニュアル

D318T USER MANUAL (Touch Screen Type with Remote Control)

12．DELETE ALL REMOTE CONTROL

PC－－9－－re-enter PC－

Hear 1 beep and Light indicator illuminates green.

13．RESTORE TO FACTORY SETTINGS

Remove one battery for 10 seconds, reinsert the battery and wait for a long and short beeps. Press button 3 times
within 3 Seconds.

Restore PC to 123456, default password to 1234, all user codes will be deleted, all remotes will be deleted. All back to
default settings including Auto-lock function is off, Sound is on etc.

15．Audio and Visual Message Guide

ALL SAME AS KEYPAD TYPE EXCEPT:

Incorrect Code Entry Attempts: Warning sounds and LED flashes red after 4 incorrect code attempts, Touchscreen shuts down
for 60 seconds.

16 . NEW ATTENTION PART(CAN BE NOTED BY AFTER SALE SERVICE ONLY)

When battery is under low voltage, the lock will warning and during this time the lock can still work.

However once the voltage is lower than 4.3V (Called Super-low Voltage), the operation of Lock/Unlock

the door cannot be done, user must replace the new batteries immediately.

17 . FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired

operation.

Please take attention that changes or modification not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

Note: This product has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This product generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this product does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.