Vital Home Systems LLC 1050 ユーザーズマニュアル

P a g e

| 6

Operation

IMPORTANT NOTICE TO USER:  The installation of
any  water  detection  or  automatic  water  shut  off
system does NOT guarantee water will be detected
on  all  occasions  or  circumstances.    Due  to  the
variety  of  environments  the  system  can  be
installed,  how  it  is  maintained  and  types  of
installation,  Vital  Home  Systems  does  NOT
guarantee  or  warrant  against  water  or  property
damage  as  a  result  of  or/with  the  use  of  this
system.

Upon receiving the signal from the Water Sensors or
VC100, the VHS-1050 will flash the Dialer LED and
play the appropriate message for specific event and
time period.

NOTE:

 For VC-100 / 4LWS, it will play appropriate

voice message locally for 15 seconds before
dialing out.

 If two or more sensors are triggered one

after another, the corresponding messages
will be played in rotation.

 After dialing a phone, and the line is not

engaged, the Dialer LED will flash ON and
the Dialer will automatically play the
appropriate message on a remote phone to
summon help.

 If no telephone number is stored, the Dialer

will not dial to report.

 When two or more telephone numbers are

stored, the Dialer will dial in accordance to
the Priority Order number. If the number
being dialed cannot connect, it will try the
next number.

 Each phone number will be tried in

rotation, with the Dialer making a maximum
of 10 calls in total.

 When the recipient answers the phone, the

voice message will play, this must be
acknowledged by pressing “9” in order for
the VHS-1050 to stop dialing and go back on
hook.

 If VHS-1050 does not receive the

acknowledgement from receiver within 60
seconds, it will automatically go back on
hook. After five seconds, it will again start
the dialing.

 When a total of 10 calls have been made to

the stored telephone numbers without any
acknowledgement, the Dialer returns to
Normal Mode. The Dialer LED will continue
to flash to remind the user of the reporting
failure.

 During dialing, if the Dialer receives a

disarm signal from the Dialer (when its
“ACK” key is pressed) the Dialer LED goes
OFF and the Dialer stops the reporting.

 The 1050 phone numbers entered are to be

for cell phone numbers only that way if a
line is busy when called it will leave a voice
mail.

Fault Situations

The Orange LED (Fault LED) will flash ON if the VHS-
1050 or any of the Learned devices are out-of-order
or in low-battery status.

 When there is Fault situation indicated by

Orange LED ON, the VHS-1050 Dial out to
the numbers in the phonebook in order of
priority with Sensor/Valve name with a
“Low Battery” or “Fault Detected”.

 When there is Fault situation indicated by

Orange LED ON, pressing “ACK” will play the
corresponding voice message for 30
seconds or till CLR is pressed.

 When there is no Fault, pressing “ACK” will

produce no response.

 The Orange LED will turn OFF automatically

once all of the faulty conditions are
restored, or faulty devices are removed via
the software.

Supervision Fault

 VC-100 will send “I’m Here” signal to the VHS-

1050 every 24~30 hours. If the VHS-1050 has
not received the signal for seven (7) days, it
will cause Out-of-Order fault condition.

 WATER SENSOR will send “I’m Here” signal to

VHS-1050 every four hours; if the VHS-1050
has not received the supervision signal for 12
hours, it will cause an Out-of-Order fault
condition.