Presidio Networked Solutions Inc. AIO3 ユーザーズマニュアル
9
This document contains information and data which is proprietary to Presidio that shall not be duplicated, used, or disclosed - in whole or in part
- for any purpose other than to evaluate this product.
AIO3.0 User’s Manual
PRES058-150422 REV 4
rate for several seconds. The LED will turn off which indicates the unit is on.
e) Press and Hold the Status Button for a minimum of 5 seconds. After the button is released the 3
status LED’s will indicate the device status as shown below. The LED’s will indicate status for
up to 5 minutes and then all LED’s will go out. The device is still on and operational though no
LED’s are illuminated.
up to 5 minutes and then all LED’s will go out. The device is still on and operational though no
LED’s are illuminated.
Battery Status
LED Status
Device Off (Battery needs charged)
Permanently Off
< 25% Battery Charge
Blinking - Log off – Short on
Approximately 50% Battery Charge
Blinking - equal on and off time
>75% Battery Charge
Blinking - Log On – Short Off
100% Battery Charge
Permanently On
Network Status
LED Status
No Network
Permanently Off
Network Available however not connected
to Presidio server
to Presidio server
Blinking
Network Available, connected to Presidio
server
server
Permanently On
GPS Status
LED Status
No Navigation
Permanently Off
Navigation
Permanently On
f)
If the Status LED indicates the unit is connected to the network, the device can be pinged
(monitored) from the mapping application software to confirm the overall status of the device.
The user can check GPS position, internal battery status and the general signal
strength from the wireless network.
(monitored) from the mapping application software to confirm the overall status of the device.
The user can check GPS position, internal battery status and the general signal
strength from the wireless network.
3.1
INSTALLATION
3.1.1 Vehicle Installations