InVue F1671 ユーザーズマニュアル
Place the stand in the desired
location and apply pressure for at
least 10 seconds.
location and apply pressure for at
least 10 seconds.
15
Charger Installation:
Peel the backing from the circular
adhesive.
adhesive.
16
Place the adhesive on the end of the
stand’s arm. Apply pressure for at
least 10 seconds.
stand’s arm. Apply pressure for at
least 10 seconds.
17
Orient the charger with the cable
facing towards the stem and place
onto the adhesive. Apply pressure for
at least 10 seconds.
facing towards the stem and place
onto the adhesive. Apply pressure for
at least 10 seconds.
18
Remove the cable cover from the
stem and route the charger cable into
the channel as shown. Replace the
cable cover to its original position to
hold the cable in place.
stem and route the charger cable into
the channel as shown. Replace the
cable cover to its original position to
hold the cable in place.
19
1
2
Pull the quick connect adapter from
the unit.
the unit.
21
Snap the cover onto the charger.
20
Peel the liner from the adhesive.
To connect the sensor head, pull
back the barrel on the recoiler cable.
back the barrel on the recoiler cable.
22