Insight Energy Ventures DBA Powerley N1O9A911 ユーザーズマニュアル
Powerley
Energy Bridge Setup Guide 3
Energy Bridge Setup
1.
Launch setup within [app name] app
Launch the [app name] app on your mobile device and navigate
to the My Devices from the main menu. Tap on the green "Begin
Energy Bridge Setup" button and follow the remaining steps here
along with the app instructions.
4.
Connect to Account
Now that your Energy Bridge has been located, you are now ready
to connect to your account. Tap "Connect to Account" on the
app to continue. When the app notiies you that your account is
successfully connected, tap "Next Step."
5.
Connect Energy Bridge to Internet via WiFi
If your Energy Bridge is more than 25ft away from your Smart Meter
with a wired connection, move it within 5-25ft to increase signal
reliability to your meter. Plug it into a power outlet and tap "Set Up
WiFi" on the app. Select your WiFi network and connect to it. Once
connected, tap "OK, I Moved it" on the app to continue.
6.
Bind Energy Bridge to Smart Meter
To securely connect your Energy Bridge to your Smart Meter, tap
"Request Bind." Wait [time period] and tap "Check Bind Status" in
the app. If bind was successful, you're all done!
2.
Connect Energy Bridge to power and Internet
Plug your Energy Bridge into a power outlet using provided cable. If
your router is within 25ft of your home's Smart Meter, continue with
a wired connection by plugging the Energy Bridge into an available
port on your WiFi router with second cable and skip steps #–#.
3.
Locate Energy Bridge with your mobile device
Before locating, be sure that your mobile device is connected to the
same WiFi network as your Energy Bridge. Tap the "Start Locating"
button on the app to locate Energy Bridge. When the app notiies
you it's been successfully located, tap "Next Step."
NOTE If router is more than 25ft away from Smart Meter, do not
plug Energy Bridge into the router; skip to next step.
NOTE If the Energy Bridge is unable to bind, try connecting the
Energy Bridge via WiFi if you have not already done so, move it
closer to you Smart Meter, and tap "Request Bind Again." If the
issue persists, contact support directly from within the app.