Insight Energy Ventures DBA Powerley N1O9A911 ユーザーズマニュアル

Powerley   

   Energy Bridge Setup Guide  5

This device complies with part 15 of the FCC Rules. 

Operation is subject to the following two conditions: (1) This device 

may not cause harmful interference, and (2) this device must accept 

any interference received, including interference that may cause 

undesired operation.

FCC Part 15.21 Statement

Changes or modiications made to this equipment not expressly 

approved by the party responsible for compliance could void the 

user's authority to operate the equipment.

FCC Part 15.105 Compliance Statement

This equipment has been tested and found to comply with the limits 

for a Class B digital device, pursuant to Part 15 of the FCC Rules.

FCC RF Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set 

forth for an uncontrolled environment. End users must follow the 

speciic operating instructions for satisfying RF exposure compliance. 

This transmitter must be at least 20 cm from the user and must not 

be co-located or operating in conjunction with any other antenna or 

transmitter.

NOTE

This equipment has been tested and found to comply with the limits 

for a Class B digital device, pursuant to part 15 of the FCC Rules. 

These limits are designed to provide reasonable protection against 

harmful interference in a residential installation. This equipment 

generates, uses and can radiate radio frequency energy and, if not 

installed and used in accordance with the instructions, may cause 

harmful interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular installation. 

If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the 

equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures:

•  Reorient or relocate the receiving antenna.

•  Increase the separation between the equipment and receiver.

•  Connect the equipment into an outlet on a circuit different from 

that to which the receiver is connected.

•  Consult the dealer or an experienced radio/TV technician for help.  

Industry Canada (IC) regulatory information

This device complies with Industry Canada license-exempt RSS 

standard(s). Operation is subject to the following two conditions: 

(1) this device may not cause interference, and (2) this device must 

accept any interference, including interference that may cause 

undesired operation of the device.

Le présent appareil est conforme aux CNR d´Industrie Canada 

applicables aux appareils radio exempts de licence.

L´exploitation est autorisée aux deux conditions suivantes : (1) 

l´appareil ne doit pas produire de brouillage, et (2) l´utilisateur de 

l´appareil doit accepter tout brouillage radioélectrique subi, même si 

le brouillage est susceptible d´en compromettre le fonctionnement

Regulatory Information