The Watt Stopper Inc. d/b/a Qmotion QMRS-908 ユーザーズマニュアル

 5 

 

Read and understand each section before performing required steps 

During FIRST TIME SETUP after Step 3. TUG, a Z-Wave Plus controller must be paired to the shade within 90 seconds. 
Otherwise, the shade will time-out and require another attempt. JOG is a short up and down movement.  A double JOG 
from the current position will indicate failure on the device add.  The process should be  restarted if the expected results 
differ or a double jog failure indication is received.  

 
FIRST TIME SETUP (Z-Wave ADD) 
1. INSTALL SHADE following the shade installation instructions. 
2. Place the Z-Wave controller into ADD device mode. 
3. Now perform two micro tugs, short pause between them. 

__ 

(Shade will move to Upper Limit Position, then down a small amount) 

4. Now perform one short tug and wait for 5 seconds. 

__ 

(Shade will move to Upper Limit Position, then down a small amount) 

5. Now the Z-Wave controller will query new device. 
     (Controller signals that a new device has been discovered) 
 
SETTING LOWER LIMIT (Only if shade has never been added to a controller) 
1. Slowly TUG the HEMBAR to the lower limit position 

__ 

(Shade should move smoothly to fully closed position and remain) 

__ 

(Shade will move to fully open position, jog and back to full open) 

     
 
To REMOVE shade from controller (Z-Wave REMOVE) 
1. Place the Z-Wave controller into REMOVE device mode. 
2. Now perform two micro tugs, short pause between them. 

__ 

(Shade will move to Upper Limit Position, then down a small amount) 

3. Now perform one short tug and wait for 5 seconds. 

 _ 

(Shade will move to Upper Limit Position, then down a small amount) 

4. Now the Z-Wave controller will remove the device. 
     (Controller signals that a new device has been removed)