The Watt Stopper Inc. d/b/a Qmotion QMRS-908 ユーザーズマニュアル
6
IMPORTANT
When unrolling the shade to expose battery cover, the shade may try to roll upward. Hold the FABRIC ROLL TUBE firmly in
place to resist the initial upward movement, then continue to unroll the FABRIC ROLL TUBE to expose battery cover.
place to resist the initial upward movement, then continue to unroll the FABRIC ROLL TUBE to expose battery cover.
BATTERY REPLACEMENT
1. Now perform two micro tugs, short pause between them.
__
(Shade will move to Upper Limit Position, then down a small amount)
2. Now perform four short tugs (pause between) and wait for 5 seconds.
__
(Shade will move to fully open position, jog, and back to full open)
3. Shade will go into battery replacement mode and should not respond to tugs.
(Battery replacement mode will be exited on next power up)
4. Proceed with battery replacement.
(As soon as batteries are installed the shade should move to fully open and stop)
5. UNROLL the FABRIC ROLL TUBE to expose the battery cover (See IMPORTANT information above)
6. REMOVE battery cover and REPLACE with new NEW D-CELL Alkaline batteries
7. REPLACE battery cover
(Shade will now move to fully open and remain paired to controller)
FACTORY (MASTER) RESET (Will remove ALL paired controllers and calibration settings)
(Shade at Upper Limit Position)
1. Perform two micro tugs, short pause between them.
(Battery replacement mode will be exited on next power up)
4. Proceed with battery replacement.
(As soon as batteries are installed the shade should move to fully open and stop)
5. UNROLL the FABRIC ROLL TUBE to expose the battery cover (See IMPORTANT information above)
6. REMOVE battery cover and REPLACE with new NEW D-CELL Alkaline batteries
7. REPLACE battery cover
(Shade will now move to fully open and remain paired to controller)
FACTORY (MASTER) RESET (Will remove ALL paired controllers and calibration settings)
(Shade at Upper Limit Position)
1. Perform two micro tugs, short pause between them.
__
(Shade will move to Upper Limit Position, then down a small amount)
2. Now perform eight short tugs (pause between) and wait for 5 seconds.
__
(Shade will move to fully open position, jog, and back to full open)
SHADE CALIBRATION (setting lower limit)
1. Now perform two micro tugs, short pause between them.
__
(Shade will move to Upper Limit Position, then down a small amount)
2. Now perform two short tugs (pause between) and wait for 5 seconds.
__
(Shade will move to Upper Limit Position, then down a small amount)
3. Set desired closed position.
A. From Z-Wave Controller:
1. Use On/Off controls to nudge the shade towards the desired close position
B. Manually from shade:
1. Roll or Pull shade to desired closed position
(Shade should remain at the set location)
4. From the Z-Wave controller, select the device to calibrate.
5. Command shade to a position that is NOT On or Off.
4. From the Z-Wave controller, select the device to calibrate.
5. Command shade to a position that is NOT On or Off.
__
(Shade will move to fully open position, jog, and back to full open)
IMPORTANT
Lower Limit Position should be set after the first ADD of the device by using the FIRST TIME ADD procedure. The double job
action is an indication of failure and the process is aborted. If the expected results differ or a failure is indicated, restart the
calibration process.
action is an indication of failure and the process is aborted. If the expected results differ or a failure is indicated, restart the
calibration process.