RuiXingHengFang Network Co. Ltd. 76052 ユーザーズマニュアル
V2.6 2015-12-03
www.risinghf.com
LoRaWAN Module RHF76-052 User Manual
RisingHF
26
AT+FDEFAULT=RISINGHF
Return:
+FDEFAULT: OK
Item
Value
Channel
3 channels
CH0: 868.1MHz
CH1: 868.3MHz
CH2: 868.5MHz
Datarate Range
DR0 : DR5
Unconfirmed Message Repetition
1
Confirmed Message Retry
3
Port
8
Datarate
DR0
ADR
ON
Power
14dBm
RXWIN2
869.525MHz, DR3
RXWIN1 Delay
1s
RXWIN2 Delay
2s
JOIN ACCEPT RXWIN1 Delay
5s
JOIN ACCEPT RXWIN2 Delay
6s
Table 6- 4 Factory default configuration
NOTE: Customized modem may be precompiled to use a different factory default configuration. If any user has request, please contact
RisingHF
8.19 DFU
Use to enter DFU mode. If user need to enter DFU mode to update LoRaWAN modem firmware, then
user should first send "AT+DFU=ON" command to enable firmware upgrade. Once DFU mode is on,
user should repower LoRaWAN modem (unplug and plug back), after repowered LoRaWAN will enter
DFU mode, user could use DfuSe tool to update the firmware. If user want to exit DFU mode without
upgrade, user just need to repower again, LoRaWAN modem will exit DFU mode automatically.
For UART bootloader, "AT+DFU=ON" command will make device enter bootloader mode automatically.
Format:
AT+DFU="New state"
eg: AT+DFU=ON
eg: AT+DFU=ON
// Enable DFU function
eg: AT+DFU=OFF
// Disable DFU function
AT+DFU=?
// Check if DFU is enabled configuration
Return:
+DFU: ON
+DFU: OFF
+DFU: OFF
Example: (RHF76-052AM/RHF76-052AN)
+DFU: ON
Enter bootloader mode after reboot
Enter bootloader mode after reboot
7
Confirmed message retry number of time is fixed value, which can’t be change through AT command.