RuiXingHengFang Network Co. Ltd. 76052 ユーザーズマニュアル
V2.6 2015-12-03
www.risinghf.com
LoRaWAN Module RHF76-052 User Manual
RisingHF
31
AT+TEST=?
// Query test mode and RF configuration
Return Error:
+TEST: ERROR(-12)
When come with ERROR(-12), user could try "AT+MODE=?" to check if LoRaWAN modem is in TEST mode, if not user should enter test
mode first.
Return STOP:
+TEST: STOP
+TEST: RFCFG F:433300000, SF12, BW125K, TXPR:8, RXPR:8, POW:14dBm
+TEST: RFCFG F:433300000, SF12, BW125K, TXPR:8, RXPR:8, POW:14dBm
Return TXLRPKT:
+TEST: TXLRPKT
+TEST: RFCFG F:433300000, SF12, BW125K, TXPR:8, RXPR:8, POW:14dBm
+TEST: RFCFG F:433300000, SF12, BW125K, TXPR:8, RXPR:8, POW:14dBm
Return RXLRPKT:
+TEST: RXLRPKT
+TEST: RFCFG F:433300000, SF12, BW125K, TXPR:8, RXPR:8, POW:14dBm
+TEST: RFCFG F:433300000, SF12, BW125K, TXPR:8, RXPR:8, POW:14dBm
Return TXCW:
+TEST: TXCW
+TEST: RFCFG F:433300000, SF12, BW125K, TXPR:8, RXPR:8, POW:14dBm
+TEST: RFCFG F:433300000, SF12, BW125K, TXPR:8, RXPR:8, POW:14dBm
8.25.4 Set RF Configuration
RFCFG supports set frequency, SF, band width, TX preamble, RX preamble and TX power settings.
TX and RX shares all configuration except "preamble length", user could choose different preamble
length. For LoRa communication, it is strongly recommended to set RX preamble length longer than
TX's. Bandwidth only supports 125KHz / 250KHz / 500KHz.
Depend on Semtech SX1276 (PA_BOOST/RFO) and design solution of RisingHF module, MAX output
power of different band LoRaWAN modem could be different. Check below table about the details.
Device
Bootloader
Interface
LF Band
HF Band
RHF3M076
USB
USB
20dBm
14dBm
RHF76-052AM
UART
UART
20dBm
14dBm
RHF76-052AN
USB
UART
20dBm
14dBm
Table 6- 6 MAX output power of HF and LF band
RHF3M076 is part number of RisingHF LoRaWAN modem.
Format:
"[ ]" means the parameter is omissible together with parameters after it
12
LF Band: Frequency is less than 525MHz
13
HF Band: Frequency is larger than 525MHz