Dataram 32GB DDR3-1333 PC3L-10600L 240-pin LRDIMM DRF1333LR/32GB プリント
製品コード
DRF1333LR/32GB
DRF1333LR
DDR3-1333, PC3L-10600L, ECC, 1.35V, 240-pin LRDIMMs
DRF1333LR
12-Jun-12
Copyright
2012 Dataram Corporation | U.S.A. Headquarters +1 609-799-0071 | Offices in Europe and Asia | www.dataram.com
The information contained in this document has been carefully checked and is believed to be reliable and accurate. However, Dataram assumes no responsibility for errors.
Products in Family
DRF1333LR/16GB (1 x 16GB 4Rx4 LRDIMM)
DRF1333LR/32GB (1 x 32GB 4Rx4 LRDIMM)
DRF1333LR/32GB (1 x 32GB 4Rx4 LRDIMM)
Features
Description
240-pin JEDEC-compliant DIMMs
133.35 mm wide by 30 mm high (1.181
133.35 mm wide by 30 mm high (1.181
” x 5.25”)
Data Transfer Rate: 10.6 Gigabytes/sec
Operating Voltage: 1.35V (1.28V~1.45V)
Backward compatible: 1.5V(1.425V~1.575V)
Fully RoHS Compliant
Thermal Sensor
Heat Spreader
Operating Voltage: 1.35V (1.28V~1.45V)
Backward compatible: 1.5V(1.425V~1.575V)
Fully RoHS Compliant
Thermal Sensor
Heat Spreader
Each DRF1333LR upgrade consists of a single load
reduced memory module, which conforms to JEDEC's
DDR3, PC3-10600L standard. Each DIMM is Quad-Rank.
The ranks are comprised of eighteen DDP (Dual Die
Pack) DDR3 SDRAMs. One 2K-bit EEPROM is used for
Serial Presence Detect and an Isolation Memory Buffer,
which enables higher system memory bandwidth at
DDR3 speeds up to 1333 MT/s.
reduced memory module, which conforms to JEDEC's
DDR3, PC3-10600L standard. Each DIMM is Quad-Rank.
The ranks are comprised of eighteen DDP (Dual Die
Pack) DDR3 SDRAMs. One 2K-bit EEPROM is used for
Serial Presence Detect and an Isolation Memory Buffer,
which enables higher system memory bandwidth at
DDR3 speeds up to 1333 MT/s.
Dataram Product
Fujitsu Product
Supported in these Fujitsu systems:
DRF1333LR/16GB
DRF1333LR/32GB
DRF1333LR/32GB
S26361-F3698-E516
S26361-F3698-E517
S26361-F3698-E517
Fujitsu Primergy TX300 S7, RX200 S7, RX300 S7,
RX350 S7
RX350 S7
Notes
Tolerances on all dimensions
except where otherwise
indicated are
except where otherwise
indicated are
.13 (.005).
All dimensions are expressed
in millimeters [inches]
in millimeters [inches]