Tripp Lite B125-101-60 ユーザーズマニュアル

1

Connect the HDMI source to the HDMI input on the local transmitter

unit.

2

 Connect the TMDS RJ45 port on the local transmitter to the TMDS 

RJ45 port on the remote receiver using Cat5e/6 cable. 
Note: See the installation diagrams for maximum extension 

3

 Connect the DDC RJ45 port on the local transmitter to the DDC 

RJ45 port on the remote receiver using Cat5e/6 cable. 
Note: See the installation diagrams for maximum extension 

4

Connect the HDMI output on the remote receiver to the HDMI monitor.

5

Connect the external power supply to the remote receiver, and then

plug it into a Tripp Lite Surge Suppressor, Uninterruptible Power

Supply (UPS), or Power Distribution Unit (PDU). The Green LEDs on

both the local and remote units will illuminate to indicate that power 
is being received. The Orange LED on the remote unit will illuminate
to indicate that a connection has been made with the local unit via

Cat5e/6 cable.

6

Turn on the power to the HDMI source. The Orange LED on the local

unit will illuminate to indicate it is receiving a signal from the source.

7

If necessary, use the equalization control to adjust the video image.

Installation and Operation

201109193-93-3144.indd   3

10/7/2011   2:29:40 PM