Turbo Air TBC-24SD, 24SB ユーザーズマニュアル

8

- Be sure the power cord is connected to the proper voltage.
- A protected circuit of the correct voltage and amperage must be run for connection of

the line cord.

- Turn ‘off’ the power switch before disconnecting the power cord, whenever

performing maintenance functions or cleaning the refrigerated cabinet.

- Compressor warranties are void if compressor burns out due to low voltage.

- If disconnected, wait 5 minutes before re-starting.

- Do not obstruct the air inlet which is located at the back inside of the unit.

Before cleaning, turn unit off at power switch.

- The interior and exterior of the unit can be cleaned using warm water with soap.
- Do not use an abrasive cleaner because it will scratch the surface.

- To maintain proper refrigeration performance, the Condenser coil must be free of

dust, dirt, and grease.

This will require periodic cleaning. Condenser fins should be cleaned at least every
three months (90 days) or as needed.

- To clean condenser, unplug at power cord. Condenser can be cleaned with vacuum.

brush, or CO

2

(high pressure air).

- Empty the Drain Pan which is located under the unit, periodically.
- When reinstalling Drain Pan, make sure Drain Hose is placed back in pan.

- Plug unit back in and turn on power switch.
- Check that the unit is operating properly.