Kelvinator KCGM24RW ユーザーズマニュアル
Circuit Diagram
8
Note:
• Conductor of at least 0.75mm
2
shall be used
for wiring of defrost and evaporator fan
control load.
control load.
• Conductor of at least 1.0mm
2
shall be used
for wiring of compressor control load.
• The inrush current for compressor may be
20A instead of 8A during the 1 second
period at the start.
period at the start.
Notes for Installation
• Before wiring, please read the
instructions carefully and be sure to
understand the function of every
contact so that you can make correct
wire connections. Control loads cannot
exceed the ratings.
understand the function of every
contact so that you can make correct
wire connections. Control loads cannot
exceed the ratings.
• The temperature controller cannot be
installed in an area where water flows,
a dirty area, an area of high moisture,
or in an area with high temperatures.
Please pay attention to EMC problems
and prevent the
a dirty area, an area of high moisture,
or in an area with high temperatures.
Please pay attention to EMC problems
and prevent the
temperature controller from collisions
with other objects.
• The sensor cable leads must be kept
away from the main supply in order to
avoid high frequency noise. 0.75‐
1.5mm
avoid high frequency noise. 0.75‐
1.5mm
2
flexible cords should be used
for wiring control load terminals.
• The evaporator sensor must be installed
between the fins of the evaporator in
the area where ice is the thickest. Do
not place the evaporator sensor near
the electric heater.
the area where ice is the thickest. Do
not place the evaporator sensor near
the electric heater.
• If the temperature controller is
disturbed, please cut off the power
supply and reset. The software of this
product belongs to grade A, and it does
not apply to safe control.
supply and reset. The software of this
product belongs to grade A, and it does
not apply to safe control.
• Please don’t dismantle the controller. If
you need repairing or you have any
problems in using the controller, please
do not hesitate to contact our
company.
problems in using the controller, please
do not hesitate to contact our
company.