Intermec 069427-003 ユーザーズマニュアル
nugget
Replacing Parts
2-35
2
7. If you removed a standard scan engine or PDF 417 scan engine in Step 3, install the
scan engine assembly.
a.
Place the assembly in the bottom
cover. Make sure the assembly is
firmly seated in the cover.
cover. Make sure the assembly is
firmly seated in the cover.
b. Slide the assembly toward the top
of the cover so that the front of
the assembly slides under the
retainers.
the assembly slides under the
retainers.
c.
Install the two screws that hold
the scan engine assembly in place
and tighten them to 0.565 Nm
(5 in-lb).
the scan engine assembly in place
and tighten them to 0.565 Nm
(5 in-lb).
Retainers
241XM025.eps
8. If you removed an E1022 linear imager in Step 3, place the E1022 linear imager
assembly in the bottom cover and install the four screws that hold the assembly in
place. Tighten the screws to 0.565 Nm (5 in-lb).
place. Tighten the screws to 0.565 Nm (5 in-lb).
9. (2415 only) Install the radio card.
a.
Compare the connector tabs on the radio card to the connector on the main PCB
to determine which way to insert the card.
to determine which way to insert the card.
b. Slide the radio card into the connector. Firmly press the card into the connector
until it stops.
c.
Install the retaining block on the main PCB and tighten the screw to 0.226 Nm
(2 in-lb).
(2 in-lb).
10. Attach the appropriate scanner safety label and RF certification label. For 2410
terminals and RM182 OpenAir, 2126 802.11b, and PC24-11-FC/R 802.11b radios,
use standard print on demand practices to print the RF certification label.
use standard print on demand practices to print the RF certification label.
241XM037.eps
Serial
number
label
number
label
Scanner
safety
label
safety
label
RF certification
label
label