Netgear DUALBAND WLAN WNDAP360 N300 AP WNDAP360-PES ユーザーズマニュアル
製品コード
WNDAP360-PES
Installation and Basic Configuration
16
ProSafe Dual Band Wireless-N Access Point WNDAP360
In order for this to work correctly, verify that you have met all of the system requirements,
shown in
shown in
Install and configure your wireless access point in the order of the following sections:
Connect the Wireless Access Point to Computer
Tip:
Before you place the wireless access point in an elevated position that is
difficult to reach, first set up and test the wireless access point to verify
wireless network connectivity.
wireless network connectivity.
To set up the wireless access point:
1.
Unpack the box and verify the contents.
2.
Prepare a computer with an Ethernet adapter. If this computer is already part of your
network, record its TCP/IP configuration settings. Configure the computer with a static IP
address of 192.168.0.210 and 255.255.255.0 as the subnet mask.
network, record its TCP/IP configuration settings. Configure the computer with a static IP
address of 192.168.0.210 and 255.255.255.0 as the subnet mask.
3.
Connect an Ethernet cable from the wireless access point to the computer (point A in the
following figure).
following figure).
4.
Securely insert the other end of the cable into the wireless access point’s Ethernet port
(point B in the following figure).
(point B in the following figure).
.
Figure 4.
A
B
Ethernet cable
Ethernet port
WNDAP360