Netgear DUALBAND WLAN WNDAP360 N300 AP WNDAP360-PES ユーザーズマニュアル

Turn on your computer.

Connect the power adapter to the wireless access point.

The wireless access point supports Power over Ethernet (PoE). If you 

have a switch that provides PoE, you will not need to use the power 
adapter to power the wireless access point. This can be especially 
convenient when the wireless access point is installed in a high location 
far away from a power outlet.

Verify the following:

Power/Test LED. The Power/Test LED blinks when the wireless access point is 
first turned on. (To be exact, during startup, the LED is first steady amber, then 
goes off, and then blinks green.) After about 45 seconds, the LED should stay lit

 

             (steady green). If after 1 minute the Power/Test LED is not lit or is still blinking,

 

             check the connections and see if the power outlet is controlled by a wall switch

 

             that is turned off.

Active LED. The Active LED is lit or blinks green when there is Ethernet traffic.

LAN LED. The LAN LED indicates the LAN speed: green for 1000 Mbps, amber 
for 100 Mbps, and no light for 10 Mbps. If the LAN LED is not lit, make sure that 
the Ethernet cable is securely attached at both ends.

WLAN LED. The 2.4 GHz WLAN LED is lit or blinks green when the wireless LAN 
(WLAN) is ready. 

WLAN LED. The 5 GHz WLAN LED is lit or blinks green when the wireless LAN 
(WLAN) is ready. 

Log In to the Wireless Access Point

The default IP address of your wireless access point is http://192.168.0.100. The wireless 
access point is set, by default, for the DHCP client to be disabled.



Open a Web browser such as Microsoft Internet Explorer 6.0 or later, or Mozilla Firefox 
1.5 or later. 

Connect to the wireless access point by entering its default address of http://192.168.0.100 
into your browser. The Login screen opens: