U Reach CONRAD SATA-FESTPLATTEN-CLONER/ERASER PRO118 ユーザーズマニュアル

• Connect the round low-voltage plug of the included mains adapter with the corresponding

socket (1) on the rear of the copying station.

• Connect the mains adapter to a mains socket via the included mains cable.
• Connect the two hard disc connection cables to the intended sockets on the left (4) and right

(9) of the copy station.

• Switch on the copy station (put the rocker switch on the rear in the position “I”).



The hard discs can be connected before or after the copy station is switched on.
Due to its integrated protective function, copy station only switches on the operating
voltage for the hard discs when the copy process is started.

The display only shows the starting process for a few seconds:

Then the main menu appears:

• Place the hard discs on the included protective mats. This protects not only the table

surfaces from scratches, but also the hard disc from damage.

Attention!
Do not move the hard discs when they are in operation; they may be damaged by
this.
The operating voltage for both hard discs is switched off, e.g. when a copy process
was completed. Then wait for at least 15-20 seconds for the magnetic discs in the
hard disc to come to rest.
Only now must the hard discs be moved or unplugged again.
If this is not observed, the writing/reading head may tough the hard disc’s magnetic
disc and damage the hard disc or cause data loss. Furthermore, this will render the
guarantee/warranty void!

HDD Duplicator

Booting...

HDD Duplicator

1.Copy