Sangean DCR-10 DCR10SW データシート
製品コード
DCR10SW
10
GB
Remote control battery replacement
1. Remove the battery cover on the rear of your remote control by
applying pressure to the catch in the direction shown by the
arrow in the diagram, and then lifting the cover.
applying pressure to the catch in the direction shown by the
arrow in the diagram, and then lifting the cover.
2. Insert 2 x AAA size batteries into the compartment. Make sure
the (+) and the (-) ends of the batteries are positioned as shown
inside the compartment.
the (+) and the (-) ends of the batteries are positioned as shown
inside the compartment.
3. Close the battery cover by inserting the retaining lugs first,
then apply pressure to the free end such that the catch latches
the cover securely.
then apply pressure to the free end such that the catch latches
the cover securely.
4. If the remote is not to be used for an extended period of time it is
recommended that the batteries are removed.
recommended that the batteries are removed.
IMPORTANT:
The batteries should not be exposed to excessive heat such
as sunshine, fire or the like. After use, disposable batteries should if
possible be taken to a suitable recycling centre. On no account
should batteries be disposed of by incineration.
The batteries should not be exposed to excessive heat such
as sunshine, fire or the like. After use, disposable batteries should if
possible be taken to a suitable recycling centre. On no account
should batteries be disposed of by incineration.
1. Battery compartment
2. Latch
3. Retaining lugs (inside)
2. Latch
3. Retaining lugs (inside)