ABUS AZ4111 ユーザーズマニュアル

 

 

19

UK 

Every partition can issue an alarm, independent of the 
other partitions. But not all users have access to all 
partitions. However, the system allows all users to switch 
off the sirens after an alarm.

 

 
The system shows an alarm in Partition A. 
 
 
 
 
 
 
 
1. Enter your user code. The sirens are switched off. The 
display shows the partitions that you can access.

 

 
 
 
 
 
 
2. Press the corresponding button to deactivate the 
required partition. Press 

. 

A partitioned system uses the same reset methods as a 
single system However, there are a few differences:

 

 
1. User reset 
Enter the user code or hold a proximity code key at the 
control unit. The display shows the partitions you can 
access.

 

 
2. Press 

. The display shows a 4-digit reset code. 

 
3. Carry out a remote reset as described in the installation 
instructions. 
 

The method used for blocking zones within the partitioned 
system has changed. Zones can no longer be blocked as 
long as the system is active.

 

 
1. Enter your access code (or proximity code key), and 
press 

. 

The display shows: 
 
 
 
 
 
 
2. Enter the number of the zone you want to block. 
If you are not authorized to block this zone, the display 
shows: 
 
 
 
 
 
 
If you are authorized to block a zone then the following is 
shown: 
 
 
 
 
 
 
If you have blocked an immediate alarm zone then the 
next time the system is activated, you are prompted to 
confirm the zone block. Press 

, and the alarm centre 

begins to activate the blocked zone. During the next 
deactivation, the blocking of the zone is once more 
deactivated.

 

A blocked 24-hour zone must be manually unblocked via 
the control unit: 
1. Enter the user code (or proximity code key) 
2. Press 

 followed by the number of the zone and 

.