Insys GPRS 5.0 serial 11-02-01-03-10.014 ユーザーズマニュアル
製品コード
11-02-01-03-10.014
Connection
INSYS GPRS 5.0 serial
36
Mai 06
5.3.3 Termination
Connections can be terminated as follows:
Manual termination using the ATH command in online command
mode
By DTR drop (for the setting AT&D2)
If the remote terminal hangs up
After switching from data mode to online mode, the connection
will remain established. However, data is no longer transmitted to
the remote terminal. The online command mode is also entered
through DTR drop (setting AT&D1) or by activating the reset input
twice within 10 seconds.
Hang up (terminate connection to the other party)
The connection was terminated.
Manual termination using the ATH command in online command
mode
By DTR drop (for the setting AT&D2)
If the remote terminal hangs up
After switching from data mode to online mode, the connection
will remain established. However, data is no longer transmitted to
the remote terminal. The online command mode is also entered
through DTR drop (setting AT&D1) or by activating the reset input
twice within 10 seconds.
Hang up (terminate connection to the other party)
The connection was terminated.
5.3.4 Connection to analogue modems
Alternatively, the settings can be entered or modified using the
terminal program.
To call an analogue modem, an analogue protocol must be set.
E.g.: The protocol V.32 with a data rate of 9600 baud.
terminal program.
To call an analogue modem, an analogue protocol must be set.
E.g.: The protocol V.32 with a data rate of 9600 baud.
5.3.5 Connection to ISDN TAs
Alternatively, the settings can be entered or modified using the
terminal program.
To call an ISDN TA it is necessary to set the ISDN protocol V.110.
While doing so it must be observed that the remote terminal has to
work with the same protocol as well.
E.g.: The protocol V.110 with a data rate of 9600 baud.
terminal program.
To call an ISDN TA it is necessary to set the ISDN protocol V.110.
While doing so it must be observed that the remote terminal has to
work with the same protocol as well.
E.g.: The protocol V.110 with a data rate of 9600 baud.
ATH
<1 sec. pause>
+++
<1 sec. pause>
+++
<1 sec. pause>
OK
AT+CBST=<n>
AT+CBST=7
AT+CBST=<n>
AT+CBST=71