Graupner Hendheld RC 2.4 GHz No. of channels: 6 33112 ユーザーズマニュアル

118 Program description: Telemetry menu

The menus grouped together under the overall heading 
“Telemetry” are called up from the basic display of the 
mx-12 HoTT transmitter by holding the central 

 

button of the left-hand four-way button pressed in for 
about three seconds. An alternative method of calling up 
this menu, which also applies to the transmitter’s other 
menus, is to briefl y press the central 

 button of the 

right-hand four-way button in the multi-function list:

mod. mem.
ser vo set.
D/R expo
wing mixer

base sett.
contr set.
phase trim
free mixer

ser vo disp

basic sett

fail-safe

telemetr y

Basic menu operation
In general terms the “Telemetry” menu is operated just 
like the other menus of the 

mx-12 HoTT transmitter. 

The few differences are described below:
You can switch between the individual pages of the Te-
lemetry menu using the arrow buttons 

ef of the left or 

right-hand four-way button: you will fi nd corresponding 
direction indicators at top right of every screen page in 
the form of angle brackets (< >); see illustrations. If only 
one angle bracket is visible, then you are currently at the 
fi rst or last page. In this case it is only possible to switch 
pages in the direction indicated by the angle bracket.
Menu lines in which parameters can be altered are 
marked with an angle bracket prefi x (>). Pressing the 
arrow buttons 

cd of the left or right-hand four-way 

button causes the “>” pointer to jump forward or back 
by one line. Lines to which you cannot jump contain no 
user-variable values.

If you wish to change a parameter, press the central 

 button of the right-hand four-way button to highlight 

the parameter (black background)). Change the value 
within the possible range using the arrow buttons of the 
right-hand four-way button, and then press the 

 but-

ton again briefl y to accept the value.
At this point you can use the arrow buttons 

cd of the 

left or right four-way button to select the desired sub-
menu. However, if the message …

… appears instead of the desired sub-menu when you 
press the central 

 button of the right-hand four-way 

button, then the transmitter has no connection to a 
receiver. In this case, switch your receiving system on, 
or re-bind the receiver you wish to address, if this should 
not be the last bound one; see “Important information” 
on the previous page.

On the fi rst screen page of the sub-menu “Setting & 
Data View”, headed …

… you cannot enter any settings. This page is for infor-
mation purposes only:

S-QUA

Signal quality in %

S-dBm

Receive performance in dBm

S-STR

Signal strength in %

R-TEM.

Receiver temperature in °C

L PACK TIME Indicates the time in ms for which 

the longest data packet was lost in 
transmission between transmitter and 
receiver

R-VOLT

Current receiver operating voltage, in 
Volt

SETTING & DATA VIEW