Texas Instruments DAC3162 Evaluation Module DAC3162EVM DAC3162EVM データシート
製品コード
DAC3162EVM
Testing and Configuration
www.ti.com
2.5
DAC31x2EVM Configuration for DAC Output
Follow this procedure to configure the DAC31x2EVM in order to test the EVM signal output.
Step 1.
Four 0-
Ω
resistors must be moved in order to configure the output of the DAC31x2 as 1:1
transformer-coupled.
•
Remove the resistors R109, R110, R111, and R112
•
Install the resistors R211, R207, R191, and R195
Step 2.
Provide the clock input: 491.52 MHz at 1.5 V
RMS
at the J9 SMA connector of the
DAC31x2EVM.
Step 3.
Turn on power to the board at J12/J13.
Step 4.
Verify the spectrum using the Spectrum Analyzer at the two DAC outputs of the
DAC31x2EVM (J3 and J2).
DAC31x2EVM (J3 and J2).
illustrates a typical transformer-coupled output using a wave analyzer.
Figure 5. DAC3162EVM Transformer-Coupled Output at 30 MHz IF
6
DAC31x2EVM
SBOU096A – November 2010 – Revised January 2011
© 2010–2011, Texas Instruments Incorporated