Ea Elektro Automatik EA Elektro-Automatik EA-EL 9080-400 HP Electronic Load 0 - 400 A 0 - 80 Vdc 0 - 4800 W 33200241 データシート
製品コード
33200241
41
Instruction Manual
EL 9000 HP Series
EN
Date: 10-31-2011
Settings
CAN Base ID
(available since firmware 5.01)
Possible settings:
0x000 (0000)
...
0x7FC (2044)
Default setting:
0x000 (0000)
Belongs to: CAN interface card IF-C1
Explanation: this adjusts the base ID for the CAN ID sy-
Explanation: this adjusts the base ID for the CAN ID sy-
stem which uses three IDs (see above at CAN ID System).
With the three IDs per unit, the system is compatible to
Vector software and the so-called CAN databases (*.dbc).
The base ID is adjustable in steps of four. Also see the
further documentation for the Vector system, which is
included with the databases.
Note: this setting is only availabe, if
Note: this setting is only availabe, if
CAN ID System:
Vector
has been selected (see above).
CAN Broadcast ID
(available since firmware 5.01)
Possible settings:
0x000 (0000)
...
0x7FF (2047)
Default setting:
0x7FF (2047)
Belongs to: CAN interface card IF-C1
Explanation: the broadcast ID is an additonal ID of the
Explanation: the broadcast ID is an additonal ID of the
Vector ID system. It is generally used to send broad-
castmessages to multiple bus members at once. Those
units, when addressed by this ID will act the same time,
executing the same command, like setting current. With
this ID, only settings or values can be sent and nothing
can be queried.
Note: this setting is only availabe, if
Note: this setting is only availabe, if
CAN ID System:
Vector
has been selected (see above).
CAN Bus terminate
Possible settings:
yes
,
no
Default setting:
yes
(since firmware 5.01), else
no
Belongs to: CAN interface card IF-C1
Explanation: defines, if the bus termination resistor on the
Explanation: defines, if the bus termination resistor on the
CAN interface card is active or not. This is only required
if the device is at the end of the CAN bus. By setting this
parameter to
yes
the resistor is activated,
no
deactivates
it. In case you don‘t want to use this feature and instead
want to install a custom resistor for bus termination, make
sure that this setting is set to
no
.
RS232 Baud rate
Possible settings:
9600 Bd
,
19200 Bd
,
38400 Bd
,
57600 Bd
Default setting:
57600 Bd
Belongs to: RS232 interface card IF-R1
Explanation: determines the baudrate (transmission
Explanation: determines the baudrate (transmission
speed) of the serial data transmission when using the
serial RS232 interface card IF-R1. Make sure, that the
other end of the serial connection operates at the same
baudrate.