Ea Elektro Automatik EA Elektro-Automatik EA-ELR 9250-140 3U Electronic Load 0 - 140 A 0 - 250 Vdc 0 - 7000 W 33200406 データシート

Page 6

EA Elektro-Automatik GmbH

Helmholtzstr. 31-33 • 41747 Viersen

Germany

Fon: +49 2162 / 3785-0

Fax: +49 2162 / 16230

A piece of equipment which is intended for disposal must, according to European laws and regulations (ElektroG, 

WEEE) be returned to EA Elektro-Automatik for scrapping, unless the person operating the piece of equipment or 

another, delegated person is conducting the disposal. Our equipment falls under these regulations and is accord-

ingly marked with the following symbol:

Decoding of the product description on the label, using an example:

Field for identification of installed options and/or special models
S01...S0x = Special models with or without options

Construction (not always given)
2U / 3U / 4U = 19” enclosure with 2U, 3U or 4U

Maximum current of the device in Ampere
Maximum voltage of the device in Volt
Series : 

8 = Series 8000 or 800, 9 = Series 9000 etc.

Type identification:
PS = Power Supply, usually programmable
PSI = Power Supply Intelligent, always programmable
EL = Electronic Load, always programmable
ELR = Electronic Load with Recovery 
BC = Battery Charger, not programmable
BCI = Battery Charger Intelligent, programmable

The equipment is intended to be used, if a power supply or battery charger, only as a variable voltage and current 

source, or, if an electronic load, only as a variable current sink.
Typical application for a power supply is DC supply to any relevant user, for a battery charger the charging of vari-

ous battery types and for electronic loads the replacement of Ohm resistance by an adjustable DC current sink in 

order to load relevant voltage and current sources of any type.

•

Claims of any sort due to damage caused by non-intended usage will not be accepted.

•

All damage caused by non-intended usage is solely the responsibility of the operator.