Atmel ATSTK600 500 Starter Kit and Development System. ATSTK600 ATSTK600 データシート

 

8133A-AVR-04/08 

devices with page size bigger than what can be transferred to STK600 in one 
command, several CMD_PROGRAM_FLASH_ISP commands must be issued. In 
such a case, only the last command should have the Write Page mode bit set. 

NOTE: Only bit 0-6 are set in the XML file, because bit 7 is not constant and must be 
controlled by the PC software. 

When value polling is used to determine when a programming operation is complete, 
poll1 must be supplied. This value indicates which value will be read from the device 
until the programmed value is read. This indicates end of programming. poll2 is used 
only for EEPROM programming. 

 

Table 4-9. Answer format. 

Answer ID 

1 byte 

CMD_PROGRAM_FLASH_ISP 

Answer id 

Status 1 

byte 

STATUS_CMD_OK, 
STATUS_CMD_TOUT, 

STATUS_RDY_BSY_TOUT 

A status value indicating the result of the 
operation 

 

This command will read data from the FLASH memory of the target device if it 
succeeds. 

XML path: /AVRPART/ICE_SETTINGS/ STK600/IspReadFlash/ 

Table 4-10. Command format. 

Command ID 

1 byte 

CMD_READ_FLASH_ISP 

Command id 

NumBytes 

2 byte 

XML: blockSize 

Total number of bytes to read, MSB first 

cmd1  

1 byte 

 

Read Program Memory command byte #1. 
Low/High byte selection bit (3

rd

 bit) is handled in 

the FIRMWARE.  

 

Table 4-11. Answer format if the command was executed. 

Answer ID 

1 byte 

CMD_PROGRAM_FLASH_ISP 

Answer id 

Status1 1 

byte 

STATUS_CMD_OK 

Indicates success. Will always read OK 

Data 

N bytes 

 

The data read from the device 

Status2 1 

byte 

STATUS_CMD_OK 

A status value indicating the result of the 
operation. Will always read OK 

 

 

Table 4-12. Answer format if the command was executed. 

Answer ID 

1 byte 

CMD_PROGRAM_FLASH_ISP 

Answer id 

Status 

1 byte 

STATUS_CMD_FAILED 

Indicates failure