Atmel Evaluation Kit AT91SAM9M10-G45-EK AT91SAM9M10-G45-EK データシート

 35

SAM9M10 [DATASHEET]

6355F–ATARM–12-Mar-13

Status Register Format 

• N: Negative, Z: Zero, C: Carry, and V: Overflow are the four ALU flags 

• The Sticky Overflow (Q) flag can be set by certain multiply and fractional arithmetic instructions like QADD, 

QDADD, QSUB, QDSUB, SMLAxy, and SMLAWy needed to achieve DSP operations.
The Q flag is sticky in that, when set by an instruction, it remains set until explicitly cleared by an MSR 
instruction writing to the CPSR. Instructions cannot execute conditionally on the status of the Q flag.

• The J bit in the CPSR indicates when the ARM9EJ-S core is in Jazelle state, where: 

– J = 0: The processor is in ARM or Thumb state, depending on the T bit

– J = 1: The processor is in Jazelle state.

• Mode: five bits to encode the current processor mode 

The 

ARM9EJ-S supports five types of exceptions. Each type drives the ARM9EJ-S in a privileged mode. The types

of exceptions are:

• Fast interrupt (FIQ)

• Normal interrupt (IRQ)

• Data and Prefetched aborts (Abort)

• Undefined instruction (Undefined)

• Software interrupt and Reset (Supervisor)

When an exception occurs, the banked version of R14 and the SPSR for the exception mode are used to save the
state.

More than one exception can happen at a time, therefore the ARM9EJ-S takes the arisen exceptions according to
the following priority order:

• Reset (highest priority)

• Data Abort

• FIQ

• IRQ

• Prefetch Abort

• BKPT, Undefined instruction, and Software Interrupt (SWI) (Lowest priority)

The BKPT, or Undefined instruction, and SWI exceptions are mutually exclusive.

N Z C V Q

J

I

F T

Mode

Reserved

Mode bits

Thumb state bit

FIQ disable

IRQ disable

Jazelle state bit

Reserved
Sticky Overflow
Overflow
Carry/Borrow/Extend
Zero
Negative/Less than

31 30 29 28 27

24

7 6 5

0