Reely RtF 630 mm 1232130 ユーザーズマニュアル

Fly large, flat circles. Do not pull on the elevator too hard to reduce the flying altitude slowly. Select the last curve 

before approaching for a landing so that you will touch down against the wind outdoors and so that, in case of an 

emergency, you would have sufficient room for landing and so that you would not have to make any considerable 

corrections to the course during the approach for a landing. 
Always ensure sufficient flying speed and do not slow down the model by reducing the flight speed too much by 

pulling too hard at the elevator. The model is only brought down with the elevator fully pulled through shortly before 

touchdown. If the landing approach was too short, you can balance this out a little with some motor thrust.
After touch-down, adjust the linkage wires for the rudder and elevator so that the digital trimming is in the centre 

position again and the model still flies straight.   

Regularly check the functional safety of your remote control and smooth running of the gear motor. All moving parts 

have to be easily movable but there should not be a clearance in the bearing.  
Clean the exterior of the model and the remote control only with a soft, dry cloth or brush. Never use any aggressive 

cleansing agents or chemical solvents, since this might damage the surfaces.

 

If you have to replace any damaged or worn parts, only use original replacement parts. 

The spare parts list is located on our website www.conrad.com in the download section to the respective product.