Reely remote control ELECTROSAILOR WILD HAWK RTF RtF 1380 mm 3391 / 408C2 データシート

• Taking out a private liability insurance is recommended. If you already have one, get some information whether the

operation of a model is covered by your insurance.

• Do not leave packaging material unattended. It may become dangerous playing material for children!

• Should questions arise that are not answered with the help of this operating manual, contact us (contact information

see chapter 1) or another expert.

• The part of the receiver antenna that hangs out of the model at the rear must neither be turned over towards the

front and fastened to the model nor cut off. The best reception results are attained if the wire hangs loose from the
model and is dragged during the flight.

• Make sure that no other models are operated within the range of the remote control on the same remote control

channel (transmitter frequency). Otherwise, you will lose control over the remote-controlled model! Always use
different channels if you wish to operate simultaneously two or several models in the immediate proximity of each
other.

• Check the function safety of your model and of the remote control system. Pay attention to visible damages such as

broken plug-in connections or damaged cables. All movable parts on the model have to be smooth running; however,
there must be no tolerance in the bearing.

• Charge the flight battery, which is necessary for operation, as well as the rechargeable battery needed in the remote

control according the instructions indicated by the manufacturer.

• As power source for the plug-in mains unit, use a 230V/50 Hz mains socket of the public mains only. Never try to

operate the device at another voltage.

• If batteries are used for the power supply of the transmitter, make sure that there is a sufficient rest capacity (battery

checker). If the batteries are empty, always replace the complete set, never individual cells only.

• Before each operation, control the settings of the trim slider at the transmitter for different steering directions and, if

necessary, set them.

• To operate your model, always pull out the telescopic antenna to its full length as otherwise the transmitters presents

a considerable lower range and the transmitter output is strained higher than average.

• Always switch the transmitter on first. It is only afterwards that you may connect the flight battery of the model or

switch the model on. Otherwise unexpected reactions of the electric model airplane may occur and the propeller
can start to turn unintentionally!

• Check the correct and secure position of the propeller before each operation.

 • Make sure that neither objects nor body parts are in the rotating and suction area of the propeller while it is rotating.