Reely remote control ELECTROSAILOR WILD HAWK RTF RtF 1380 mm 3391 / 408C2 データシート





In order to avoid a double channel assignment it may be necessary to change the crystals on your remote control
system.

For reasons of operational safety, you should only use crystals that are explicitly recommended for the
use of your remote control system by the supplier.

• While the transmitter is switched off, remove the holder for the transmitter quartz from the transmitter housing (see

ill. 2, pos. 8).

• Take the transmitter crystal out of its plastic holder. Insert the replacement crystal with a different channel in the

same frequency band. Please make sure that you place the right crystal in the holder. Transmitter crystals are
normally marked with the letter T or TX (T = “transmitter“). Put the crystal holder back into the transmitter.

To change the receiver crystal, you have to pull the receiver out of the fuselage forwards into the cabin
hood. After finishing your work, you can slide the receiver back again and attach it safely to the fuselage
with servo tape of double-sided adhesive tape. You can also safely attach the flight control (1) in the
model this way.

• When the flight battery is disconnected pull the receiver

crystal (2) from the receiver (3).

• The suitable crystal for the receiver has to be marked

with the same channel number as the transmitter crystal.
In addition it is marked with the letter code R or RX (R =
receiver).

• Insert the replacement crystal with the suitable

frequency for the transmitter into the receiver.

• Switch on the transmitter and afterwards the receiver

and check the function of the system.