Reely remote control RtF 2100 mm 1289571 データシート

Place the rudder (1) in the intended slot in the elevator (2). Imprecise fits should be carefully corrected with a cutter

knife and/or fine sand paper.
Also check if installation at an angle of 90° is possible without problems. 
When everything is perfect, attach the elevator with the rudder to the fuselage with two M3 x 40 mm screws (3).
Observe that the hinge (5) moulded onto the rudder (4) must be adjusted to a pre-made slot. The rudder must not 

catch but must run in parallel with the rudder fin.
Check if installation according to figure 2 is possible without problems. Ideally, the wing should be installed for this and

the tail unit aligned according to the illustration in figure 3.