Reely remote control RtF 2100 mm 1289571 数据表
产品代码
1289571
36
a) Mounting the Elevators and Rudders
Place the rudder (1) in the intended slot in the elevator (2). Imprecise fits should be carefully corrected with a cutter
knife and/or fine sand paper.
Also check if installation at an angle of 90° is possible without problems.
When everything is perfect, attach the elevator with the rudder to the fuselage with two M3 x 40 mm screws (3).
Observe that the hinge (5) moulded onto the rudder (4) must be adjusted to a pre-made slot. The rudder must not
Also check if installation at an angle of 90° is possible without problems.
When everything is perfect, attach the elevator with the rudder to the fuselage with two M3 x 40 mm screws (3).
Observe that the hinge (5) moulded onto the rudder (4) must be adjusted to a pre-made slot. The rudder must not
catch but must run in parallel with the rudder fin.
Check if installation according to figure 2 is possible without problems. Ideally, the wing should be installed for this and
Check if installation according to figure 2 is possible without problems. Ideally, the wing should be installed for this and
the tail unit aligned according to the illustration in figure 3.
Figure 1
Figure 2