Reely remote control Electric Glider Sky Hawk RtF 1200 mm 3389 / 408C1 データシート

製品コード
3389 / 408C1
ページ / 124
41

9. Getting started with the transmitter
In the operating instructions, the numbers in the text always refer to the figure opposite or the figures
within the section. Cross references to other figures are indicated with the respective figure number.
a) Screwing on the antenna of the transmitter
If necessary, the antenna of the transmitter is inserted as far as possible from the front/top though the circular opening
into the casing of the transmitter (see also figure 02, pos. 11) and is then turned like a screw. Seize the antenna as
much as this is possible manually. Use neither force nor tools to tighten it.
b) Inserting the Batteries/Rechargeable Batteries
For the power supply of the transmitter you will need 8 alkaline batteries (e.g. Conrad Item No. 650117) or rechargeable
batteries mignon size (AA). For ecological and also for economical reasons it is recommended to use rechargeable
batteries, since they can be recharged.
To insert the batteries or rechargeable batteries, proceed as follows:
• The battery compartment lid (1) is located on the rear
side of the transmitter. Please press the corrugated
triangle and push off the lid downward.
• Now insert the eight batteries or rechargeable batteries
in the battery compartment. Observe the correct polarity
of the individual cells. A corresponding note (3) is located
on the bottom of the battery compartment.
• Afterwards slide the lid of the battery compartment back
on from the bottom and let the locking mechanism click
into place.
Figure 4