Reely 1:8 RC model car Nitro Buggy 518100 ユーザーズマニュアル





Remove the safety clips of the car body first and then lift it from the chassis.

Put the of/off switch (A) for receiver to the „OFF“
position.

Open the receiver box (B); the lid is only connected
with a clip at the front.

Guide the aerial cable through the corresponding
opening in the lid of the receiver box.

Our advice: Protect the receiver from strong
vibrations by wrapping it, e.g. in a little foam.

Then close the receiver box.

Guide the aerial cable through the enclosed aerial
tube and plug it into the holder in the receiver box
cover.

For best range, the aerial cable must protrude from
the vehicle vertically.

Never shorten the aerial cable! Never coil the aerial cable! This greatly reduces the range.

Open the battery box (A); the lid is connected with a
clip at the side and can be opened without tools.

In the battery box, there is a two-pin red BEC
connection that comes directly from the on/off switch
of the receiver box.

Connect the receiver battery to the BEC connection;
observe correct polarity (red cable = plus/+, black
cable = minus/-).

Put the receiver battery in the battery box and close
the battery box again.

Our advice: fasten the receiver battery in the battery
box, e.g. with a pierce of hard foam or foam material.