Reely Carbon Fighter II Brushless 1:10 RC model car Electric FS53622 データシート

Stop driving immediately if the vehicle shows any unusual responses to the remote commands or if the
vehicle does not respond at all.

This behaviour could be caused by low drive batteries, low batteries/rechargeable batteries in the remote
control or by too great a distance between vehicle and remote control.

A coiled telescopic aerial, interferences on the radio channel used (e.g. radio transmissions from other
devices) or adverse transmission/reception conditions may also cause unusual responses of the vehicle.

Never point the transmitter aerial directly onto the vehicle. It will decrease range!

Since the receiver is supplied with power through the speed controller BEC and thus through the drive
battery, low or empty drive batteries will cause unintentional movement of the vehicle (e.g. twitching of the
steering servo, etc.).

For example, the voltage of the drive battery decreases for a short time under full throttle, so that the receiver
will no longer receive the required operating voltage. The vehicle will speed up, but the steering servo does
not react properly. Stop operating the vehicle at once and use a new, fully charged drive battery.

Before inserting a new, fully charged drive battery into the vehicle, wait at least 5-10 minutes until motor and
speed controller have cooled down sufficiently.

• Let go of the throttle/brake lever on the transmitter so that it goes into neutral position, and let the vehicle run out.

• When the vehicle has stopped, take off the body and turn off the speed controller.

Never touch the wheels or the drive mechanism, and make sure you do not move the throttle/brake lever at
the transmitter!

• Disconnect the drive battery from the speed controller. Disconnect the plug-in connection completely.

• Now you may turn off the transmitter.

The motor, the speed controller and the drive battery get hot during operation! Do not touch these parts
immediately after operation. Danger of burns!