Reely 1:10 RC model car Electric Truggy FS-53328-6 ユーザーズマニュアル
製品コード
FS-53328-6
59
Now install the bottom part "O" of the front fender on the chassis
using two countersunk tapping screws "P" (thread length 8 mm).
using two countersunk tapping screws "P" (thread length 8 mm).
Attach the bumper "Q" onto the lower part of the fender using two
short tapping screws "R".
short tapping screws "R".
Install the holding plate "S" between the differential and the bumper
using four tapping screws "T" (thread length 10 mm).
using four tapping screws "T" (thread length 10 mm).
Make sure that the holding plate "S" is properly aligned. Otherwise
the vehicle body support will not be upright and the body cannot
be attached.
the vehicle body support will not be upright and the body cannot
be attached.
O
P
Q
R
S
T
S
top
bottom
The H-shaped vehicle body support is attached before the body
set down. Four clips (2 at the top, 2 at the bottom) are used the
secure it at the correct height on the holding plate.
set down. Four clips (2 at the top, 2 at the bottom) are used the
secure it at the correct height on the holding plate.