Conrad Digital Thermometer Module With LED Display Kit 192147 データシート
製品コード
192147
Safety Instructions
While handling the products that come in contact with electrical voltage the valid VDE-
guidelines must be observed, especially VDE 0100, VDE 0550/0551, VDE 0700, VDE
0711 and VDE 0860.
• Before opening the device always pull out the plug or make sure that the device is
guidelines must be observed, especially VDE 0100, VDE 0550/0551, VDE 0700, VDE
0711 and VDE 0860.
• Before opening the device always pull out the plug or make sure that the device is
completely without current.
• Components, assemblies or devices may be started up only when they have been
fitted, completely insulated, in a casing. While fitting they must be completely devoid
of current.
of current.
• Tools may be used on devices, components or assemblies only when is has been
ensured that the devices have been disconnected from the power supply and
electrical charges on the components present in the devices have been discharged.
electrical charges on the components present in the devices have been discharged.
• Live cables or lines, which are connected to the device, component or assembly,
must always be checked for insulation faults or breaks. If a fault is ascertained in the
supply line, the device must immediately be taken out of service till the defective
cable has been replaced.
supply line, the device must immediately be taken out of service till the defective
cable has been replaced.
• When using electronic components or assemblies, the strict adherence to the
characteristics for electrical variables given in the description must always be
indicated.
indicated.
• If the given description for the non-commercial end-user is not clear about the
electrical characteristics applicable for the component or assembly, about how an
external wiring is to be done or which external components or auxiliary equipment
may be connected and what connected values these external components may
have, then the required information must always be obtained from an expert.
external wiring is to be done or which external components or auxiliary equipment
may be connected and what connected values these external components may
have, then the required information must always be obtained from an expert.
• Before commissioning a device it must always be checked in general, whether this
device or assembly is suitable for the application, for which it is intended to be used!
In cases of doubt, please always ask the experts, the responsible persons or the
manufacturer of the devices or assemblies used!
In cases of doubt, please always ask the experts, the responsible persons or the
manufacturer of the devices or assemblies used!
• Please note that connection or operational faults lie outside of our circle of influence.
Understandably, we are not liable for damages caused by these reasons.
• If a component is not working, it must be returned with an exact description of the
fault (specify what is not working... because only an exact description of the fault can
enable a proper repair!), the related construction manual as well as without the
casing. Understandably, we need to charge extra for assembling and dismantling
work of the casing that require a lot of time. Components already mounted cannot be
exchanged. In installations and when working with mains voltage, please always
adhere to the VDE-guidelines.
enable a proper repair!), the related construction manual as well as without the
casing. Understandably, we need to charge extra for assembling and dismantling
work of the casing that require a lot of time. Components already mounted cannot be
exchanged. In installations and when working with mains voltage, please always
adhere to the VDE-guidelines.
• Devices that are operated at a voltage > 35 V may be connected only by an expert.
• In each case it must be checked, whether the component is suitable and can be
• In each case it must be checked, whether the component is suitable and can be
used for the respective application and location.
• The commissioning may be done only when the circuit has been installed properly
insulated in a casing.