Conrad Digital Thermometer Module With LED Display Kit 192147 Data Sheet

While handling the products that come in contact with electrical voltage the valid VDE-
guidelines must be observed, especially VDE 0100, VDE 0550/0551, VDE 0700, VDE 
0711 and VDE 0860. 
•  Before opening the device always pull out the plug or make sure that the device is 

completely without current. 

•  Components, assemblies or devices may be started up only when they have been 

fitted, completely insulated, in a casing. While fitting they must be completely devoid 
of current. 

•  Tools may be used on devices, components or assemblies only when is has been 

ensured that the devices have been disconnected from the power supply and 
electrical charges on the components present in the devices have been discharged. 

•  Live cables or lines, which are connected to the device, component or assembly, 

must always be checked for insulation faults or breaks. If a fault is ascertained in the 
supply line, the device must immediately be taken out of service till the defective 
cable has been replaced. 

•  When using electronic components or assemblies, the strict adherence to the 

characteristics for electrical variables given in the description must always be 
indicated. 

•  If the given description for the non-commercial end-user is not clear about the 

electrical characteristics applicable for the component or assembly, about how an 
external wiring is to be done or which external components or auxiliary equipment 
may be connected and what connected values these external components may 
have, then the required information must always be obtained from an expert. 

•  Before commissioning a device it must always be checked in general, whether this 

device or assembly is suitable for the application, for which it is intended to be used! 
In cases of doubt, please always ask the experts, the responsible persons or the 
manufacturer of the devices or assemblies used! 

•  Please note that connection or operational faults lie outside of our circle of influence. 

Understandably, we are not liable for damages caused by these reasons. 

•  If a component is not working, it must be returned with an exact description of the 

fault (specify what is not working... because only an exact description of the fault can 
enable a proper repair!), the related construction manual as well as without the 
casing. Understandably, we need to charge extra for assembling and dismantling 
work of the casing that require a lot of time. Components already mounted cannot be 
exchanged. In installations and when working with mains voltage, please always 
adhere to the VDE-guidelines. 

•  Devices that are operated at a voltage > 35 V may be connected only by an expert. 
•  In each case it must be checked, whether the component is suitable and can be 

used for the respective application and location. 

•  The commissioning may be done only when the circuit has been installed properly 

insulated in a casing.