Siemens SPS starter kit 6ED1057-3BA00-0AA8 12 Vdc, 24 Vdc 6ED1057-3BA00-0AA8 データシート
製品コード
6ED1057-3BA00-0AA8
Reference material
5.3 Special functions
LOGO!Soft Comfort Online Help
Operating Instructions, 06/2014
Operating Instructions, 06/2014
331
Description of the function
In RUN mode, a 0 to 1 transition of the signal at input En triggers the output of your
configured message text on the display. The message text is closed after a 1 to 0 transition
at input En and if the acknowledgment attribute is not set. If the acknowledgment attribute is
set, the message text is not closed until input En=0 and the message is acknowledged at the
LOGO! with OK. The status at output Q remains 1 as long as the message text is displayed.
Of several message text functions triggered with En=1, the one with the highest priority is
Of several message text functions triggered with En=1, the one with the highest priority is
displayed. Low-priority messages can also by displayed by pressing the button on the
LOGO!.
You can switch between the standard display and the message text display by means of the
You can switch between the standard display and the message text display by means of the
LOGO! buttons and .
Restrictions
Up to five message text functions are available.
Particular characteristics to be noted when configuring
The message text can be configured in the block properties dialog. You can enter up to four
lines for each message text (the text display of the LOGO! has four rows) and set the priority.
You can move to the next line using the cursor keys or the mouse. Hit the [ENTER] key to
confirm all your entries in the block properties dialog and to close the dialog.
You may also enter the actual values of other blocks in the text lines. To do so, select the
You may also enter the actual values of other blocks in the text lines. To do so, select the
relevant block from the Block dialog. A Parameter dialog opens to display a list of all
parameters available for the selected block. The block parameter you select in this dialog is
written to the selected text line. The actual parameter value is now included when you call
the message text.
Set the "Acknowledge message" attribute to specify whether a message is be acknowledged
Set the "Acknowledge message" attribute to specify whether a message is be acknowledged
before it is closed.
Simulation mode
5.3.6.7
Softkey